DODGE F2B-DL-112 flange bearing 2 holes

DODGE F2B-DL-112 belongs to flange bearing 2 holes, part of our Bearing housings range. Tell us how many you need by WhatsApp or email and we'll get back to you promptly with a quote for F2B-DL-112 and any equivalents.

The DODGE DL series Y-bearing insert unit is a 2-bolt flange mounted bearing that holds a rotating shaft to a flat structure. It suits equipment that needs a compact, self-aligning unit that goes on quickly, such as conveyors, fans, mixers and agricultural machinery. The D-Lok locking system keeps start-up simple and cuts time spent on maintenance. MR Industrial Accessories supplies this line to customers in the United States and Latin America and helps you pick the right size.

Read the code in blocks. The letter F tells you the housing is a flange type, the digit after it gives the number of mounting holes, and B means a flange unit with an insert bearing. The DL suffix points to the D-Lok locking system, which holds the insert on the shaft with set screws. Codes such as F2B-DL-012, F2B-DL-014 or F2B-DL-100 show how the reference shifts with shaft size: the last two or three digits give the nominal diameter in inches or millimeters, depending on the series. Once you know that structure, you can order the exact replacement without guessing.

These units show up on belt conveyors, bucket elevators, blowers, centrifugal pumps and process equipment. Food plants, cement plants, tanneries and metalworking shops also use them, since the 2-bolt flange mounts easily on folded sheet metal or profile structures. The DODGE DL series is a common pick when you want a robust unit that is simple to service, with good resistance to contamination and moderate radial loads.

Selection comes down to shaft diameter, expected radial and axial load, and where the unit will run. The insert seal keeps out dust and moisture; in dirty areas or where washdowns are frequent, check which seal type you have. The D-Lok system lets you adjust the insert on the shaft with an Allen key, but align the flange before you tighten the screws so you do not introduce parasitic stresses. Factory lubrication normally covers the service life, though severe applications may call for periodic relubrication.

Flange mounted bearings have equivalents between brands, and units with similar mounting dimensions are common. Codes and locking systems, however, can differ. When you need a replacement, do not go by the code alone: compare shaft diameter, hole spacing and insert type. Send the code for your DODGE DL series unit through WhatsApp or email, along with a photo of the installation and the shaft dimensions, and the team will reply promptly with a quote and suggest equivalents or another configuration if you need one.