DODGE AN-GT-09-112-CR insert bearing

DODGE AN-GT-09-112-CR belongs to insert bearing, part of our Bearings range. Tell us how many you need by WhatsApp or email and we'll get back to you promptly with a quote for AN-GT-09-112-CR and any equivalents.

The DODGE GT series insert bearing is a ball bearing with an extended inner ring, intended for mounting in split plummer block housings and wall units. It supports radial loads and some axial thrust while allowing flexible alignment, making it suitable for equipment where these conditions are present. MR Industrial Accessories LLC supplies this line, with options for various shaft sizes and sealing configurations.

The GT series code consists of the prefix AN, the GT designation, a two-digit number for shaft diameter, and a numeric suffix for the sealing variant or locking type. For instance, AN-GT-04-012-CR fits a 3/4 inch shaft, and AN-GT-08-108-CR is for 1.1/2 inch shafts. The CR suffix, present in all references, indicates a contact seal. To select the right code, know your shaft size and housing type.

These inserts are used in belt conveyors, bucket elevators, mixers, mills, and process equipment in food, chemical, and aggregate plants. They also appear in industrial fans and low-speed transmission shafts. Their design allows bearing replacement without dismantling the entire housing, reducing downtime.

When selecting an insert, confirm that the shaft diameter matches the two-digit number in the designation and that the housing bore is compatible with the GT series. The CR seal suits environments with moderate dust or moisture; for frequent washdowns, consider additional protection. During mounting, align the housing and avoid striking the inner ring. Factory lubrication typically lasts for the service life, but in severe applications, check the seal and renew the grease.

DODGE GT series insert bearings can be interchanged with other brands' inserts of equivalent dimensions if shaft diameter, inner ring width, and locking system match. Code similarity alone is insufficient; compare housing geometry and sealing type. To replace an insert from another brand, provide the old code and shaft measurements, and we will identify a compatible alternative.

If you have the insert code or equipment model, contact us via WhatsApp or email for a prompt quote. MR Industrial Accessories LLC supplies the DODGE line and can guide you to ensure a correct replacement. Send the complete reference, shaft size, and a photo of the housing if needed.