DODGE AN-GT-06-104S-CR insert bearing

DODGE AN-GT-06-104S-CR belongs to insert bearing, part of our Bearings range. Tell us how many you need by WhatsApp or email and we'll get back to you promptly with a quote for AN-GT-06-104S-CR and any equivalents.

The Dodge GT insert bearing is a ball bearing that features an extended inner ring and a fastening system, and it fits into either split or solid housings. Conveyors, fans and pumps are among the rotating equipment that use it when a compact unit that is simple to mount is required. MR Industrial Accessories supplies this line and helps you determine the right configuration for your application.

Break the code AN-GT-06-104S-CR into its blocks to understand what you are ordering. AN stands for the insert series, GT identifies the Dodge insert bearing family, 06 gives the nominal shaft diameter, and 104S covers the fastening and sealing type. The CR suffix marks a version built with a contact seal for dusty or damp surroundings. Reading the designation this way makes it easier to request the exact replacement or the variant your equipment needs.

In US plants and throughout Latin America, these inserts turn up on belt conveyors, mixers, screens, centrifugal fans and process lines in food, chemical and aggregate operations. The GT series fits situations that call for an insert bearing with solid load capacity and straightforward mounting on commercial shafts. MR Industrial Accessories supplies them for both replacement work and new projects, and our team can suggest equivalents when you are cross-referencing another brand.

Selection comes down to a few key points: shaft diameter, fastening method (set screw, eccentric or adapter), the sealing level your environment demands, and lubrication conditions. Installation should start with a clean shaft free of burrs, set screws tightened with the correct wrench, and a check that the housing is properly aligned. Keeping the bearing well lubricated and the seal in good condition helps it reach a longer service life.

Dodge insert bearings can generally be swapped with units from other manufacturers that follow the same series nomenclature and dimensions. When replacing an existing bearing, compare the full part number along with the critical dimensions: shaft diameter, insert width and fastening type. If your housing is a special design, MR can point you to a compatible alternative.

Have the part number of the insert bearing you need? Send it to MR Industrial Accessories by WhatsApp or email and our team will respond promptly with a quote. You can also ask about other series, split plummer block housings or mounting accessories. We give direct, technical answers so your equipment stays in service.