DODGE 3-3V3.65–SH v-belt pulley

DODGE 3-3V3.65–SH belongs to v-belt pulley, part of our Power transmission range. Tell us how many you need by WhatsApp or email and we'll get back to you promptly with a quote for 3-3V3.65–SH and any equivalents.

DODGE 3V QD Sheaves are V-belt pulleys that mount on a QD bushing instead of a fixed bore. That bushing arrangement lets a maintenance team install or pull the sheave without a press, and it drives the machine through 3V section belts. Fans, pumps, compressors and conveyors are typical applications. MR Industrial Accessories supplies this line and helps buyers match the sheave to the drive.

Reading the part number tells you most of what you need. The code starts with the number of grooves, then the belt section, then the pitch diameter in inches. A callout such as 1-3V3.65–SH, for example, is a single-groove sheave for a 3V belt with a 3.65-inch pitch diameter, and the SH suffix names the QD bushing type it takes. The same logic applies to 1-3V4.5–SH and 1-3V5.0–SH, which are single-groove versions at other diameters. The bushing itself is ordered separately, so it must match the shaft.

Because the bushing carries the fit, these sheaves suit plants that run many driven machines: food and beverage lines driving pumps and fans, metalworking shops with machine tools, chemical plants with agitators, and conveying equipment. HVAC units and agro-industrial drives for mills and mixers use them as well. Changing a sheave on a shaft of a different diameter means changing the bushing, not the sheave.

Selection comes down to the power being transmitted, the shaft speed and the ratio you need. Confirm the bushing size against the actual shaft diameter and check that sheave and bushing belong together. On installation, clean the tapered surfaces, tighten the bushing screws to the recommended torque and align the sheave so belts and bearings do not wear early. The sheave itself is not lubricated; the bearings on the driven equipment are.

DODGE 3V QD Sheaves interchange with other makes that use the QD bushing system when pitch diameter, groove count and bushing size line up. For a quote, send the full sheave part number and the shaft diameter. MR Industrial Accessories serves customers across the United States and in several Latin American countries, and can point you to an equivalent or help you pick the right size.

Send the part number or the dimensions you need by WhatsApp or email and the team will reply promptly with a quote and, if you are after another variant, a compatible alternative.