DODGE 1-3V6.9–1610 v-belt pulley

DODGE 1-3V6.9–1610 belongs to v-belt pulley, part of our Power transmission range. Tell us how many you need by WhatsApp or email and we'll get back to you promptly with a quote for 1-3V6.9–1610 and any equivalents.

A DODGE 3V Taper-Lock V-belt pulley is a power transmission part that sits on the shaft and, working with the V-belt, moves motion from one pulley to another. Because it uses a Taper-Lock taper bushing, it goes on and comes off without hammering. Fans, pumps, compressors and conveyors are among the equipment where it is commonly found.

Reading the code tells you what you are holding. Take 1-3V2.8–1108: one groove, a 3V belt section, a pitch diameter of 2.8 inches and a Taper-Lock 1108 bushing. In 1-3V3.35–1610 the bushing is 1610. So the leading digit counts grooves, the 3V block sets the section, the decimal is the pitch diameter in inches, and the trailing figure names the bushing. With that in hand you can match the pulley to the drive ratio and to the room you have.

Typical duty covers food, textile, chemical and process plants, on centrifugal fans and pumps, screw compressors, conveyor belts and mixers. The design keeps vibration low and belt wear even, which holds maintenance down in round-the-clock service.

Selection starts with the power to transmit, the shaft speed and the drive ratio you want. Confirm that the number of grooves and the pitch diameter suit the belt and the driven pulley. Fit the Taper-Lock bushing clean and dry, with no lubricant, and tighten to the torque specified for that bushing size. Pulley alignment matters: misalignment shortens belt life and wears the equipment bearings.

DODGE 3V Taper-Lock pulleys interchange with other makes that share the same taper bushing system and 3V section. When swapping one out, check pitch diameter, groove count and bushing number, and we will point you to the equivalent. To get a quote, send the full part number by WhatsApp or email, for example 1-3V3.0–1108 or 1-3V4.12–1610; if you do not have it, just give the grooves, section, pitch diameter and bushing number. Our manufacturing covers split plummer block housings, roller chains and sheaves.