DBH 9936 radial shaft seal — 101.4 x 146.1 x 12.7
- Brand
- DBH
- Category
- Seals
- Subcategory
- Radial shaft seals
We reply promptly.
Tell us the quantity you need and request a quote by WhatsApp or email.
Can't find the exact model? Tell us the part number or model you need. We'll track it down and quote it, whether or not it appears in our catalog.
Description
DBH 9936 belongs to radial shaft seal, part of our Seals range. Tell us how many you need by WhatsApp or email and we'll get back to you promptly with a quote for 9936 and any equivalents.
The DBH 9936 radial shaft seal is a lip seal that keeps lubricant in and contaminants out of rotating equipment. It is sized for a 101.40 mm shaft, a 146.10 mm housing bore and a 12.70 mm height. The A 094 design defines the lip construction and material. MR Industrial Accessories supplies this brand and can help you confirm the correct seal for your application.
This seal belongs to the DBH line and carries the code 9936. The critical dimensions are: shaft 101.40 mm, housing 146.10 mm, width 12.70 mm. The A 094 designation indicates a specific lip and material configuration. Because the seal runs directly against the shaft, selection depends on matching these three dimensions to your equipment.
DBH 9936 seals are found in centrifugal pumps, electric motors, gearboxes, compressors, mixers and transmission units. They retain oil or grease inside the assembly and block dust, water and particles that would otherwise accelerate bearing and gear wear. In dirty or wet conditions, a sound seal is a key factor in equipment reliability.
Proper installation starts with checking the shaft for burrs or wear at the contact area and making sure the housing is clean and undistorted. Use suitable tools and avoid striking the lip. If the shaft has a deep groove, an offset lip or a wear sleeve may be needed. Speed, temperature and the fluid being sealed also affect selection, so consult a specialist if you are unsure.
If you need an equivalent to the DBH 9936, send the complete code, the shaft and housing dimensions, and a photo of the old part if available. We can search for alternatives within the same brand or other lines we carry, and advise you if the original seal has a special design or the equipment runs under demanding conditions.
To request a quote for the DBH 9936 seal or any other size, send the code via WhatsApp or email. We will reply promptly with the options that fit your needs.
Dimensions
- Shaft (d)
- 101.4mm
- Housing bore (D)
- 146.1mm
- Height (h)
- 12.70mm
- Design
- A 094
Frequently asked questions
- What are the dimensions of the DBH 9936 seal?
- The DBH 9936 seal has a shaft diameter of 101.40 mm, a housing diameter of 146.10 mm and a height of 12.70 mm. These are the nominal dimensions from the manufacturer's data sheet. Always verify the housing and shaft before mounting.
- Can it replace a seal from another brand?
- Yes, if the shaft, housing and height dimensions match. The A 094 design may differ from other brands, but radial shaft seals are generally interchangeable when dimensions and lip type are respected. Contact us with your equipment data to confirm.
- How do I request a quote or an equivalent?
- Write to us via WhatsApp with the code DBH 9936 or the dimensions of your seal. We can look for an equivalent in another line and will reply shortly with the options.