DBH 9826Vit radial shaft seal — 39.95 x 62 x 7.4

DBH 9826Vit belongs to radial shaft seal, part of our Seals range. Tell us how many you need by WhatsApp or email and we'll get back to you promptly with a quote for 9826Vit and any equivalents.

A radial shaft seal such as the DBH 9826Vit keeps oil or grease where it belongs and keeps dust and water out of the bearing cavity. Its three key measurements are a 39.95 mm shaft, a 62.00 mm housing bore and a 7.40 mm width. MR Industrial Accessories supplies this brand and helps maintenance and purchasing teams confirm the right seal for the fluid, speed and shaft in question.

The part falls under the DBH line and carries the code 9826Vit. In the Lx-R H configuration the seal has one lip backed by a spring, which is the usual choice when the shaft turns and the housing stays still. The elastomer lip rides on the shaft surface to hold lubricant in, while the outside diameter presses into the bore to close off the static side.

Sizing a replacement starts with three numbers: shaft diameter 39.95 mm, housing bore 62.00 mm and width 7.40 mm. Beyond those, check the fluid being sealed, the surface speed at the shaft, the operating temperature and any pressure in the system, since each of these affects lip compound and spring selection.

Seals in this size range turn up in gearboxes, centrifugal pumps, electric motors, compressors and transmission assemblies, as well as in agricultural equipment and process and material handling lines. Their job in every case is the same: retain the lubricant and block particles, water or dust before they reach bearings and gears.

Fitting matters as much as selection. Lubricate the lip before sliding it over the shaft, keep sharp edges and keyways away from the sealing surface, and press the seal in square to the shaft. A worn or scored housing bore can often be brought back with a repair sleeve.

To request a quote, send the code 9826Vit or the dimensions 39.95 x 62.00 x 7.40 mm by WhatsApp or email. The team checks the request against the manufacturer's data and can suggest equivalents or a different lip type or material if the Lx-R H design is not the best fit. A photo of the old seal, caliper readings or a housing drawing also helps confirm compatibility.