DBH 9795 radial shaft seal — 32 x 43 x 12.5

DBH 9795 belongs to radial shaft seal, part of our Seals range. Tell us how many you need by WhatsApp or email and we'll get back to you promptly with a quote for 9795 and any equivalents.

The DBH 9795 is a radial shaft lip seal built for rotating equipment, keeping lubricant where it belongs and keeping dust, washdown water and chips out. It fits a 32 mm shaft inside a 43 mm housing bore with a 12.50 mm width, which puts it in the compact, general-purpose range. Treat it as a wear part: once the lip hardens or shows marks, oil starts to escape and the seal should be changed before the bearing or bushing behind it suffers.

The item is identified by designation 9795. Its published attributes are shaft 32 mm, housing 43 mm, width 12.50 mm and Lx design. Lx refers to a single-lip seal with a spring, made for lubricated rotating shafts. DBH is one of the brands MR supplies, so order the part number exactly as it appears on the equipment data sheet or on the seal you are removing.

Seals in this size range turn up in small gearboxes, centrifugal pumps, electric motors, transmission shafts and process equipment running 32 mm shafts. In every case the job is the same: hold oil or grease inside the housing and stop dust, wash water or chips from getting in. A common location is a gearbox output or the end of a shaft supported by a single-row deep groove ball bearing.

Check the shaft for burrs or wear at the contact area and make sure the housing is clean and free of dents before installation. Coat the lip with the same grease or oil the equipment uses, then press on the outer ring only, never on the lip. A deep groove on the shaft can keep a new seal from sealing, so a wear sleeve or a different shaft size may be worth evaluating. The three dimensions plus the design type decide the selection.

To quote part number 9795, send the shaft, housing and width dimensions along with a photo of the seal and the housing. With that we can look for the equivalent in DBH or another brand MR carries, keeping the Lx design or whichever design applies. We can also tell you whether the original was superseded by a version with a dust lip or a double lip, depending on how contaminated the equipment is.

For a quote on the DBH 9795 oil seal, message us on WhatsApp with part number 9795 or with the dimensions 32 x 43 x 12.50 mm. MR Industrial Accessories supplies seals and oil seals alongside bearings, housings and power transmission parts, so if the seal sits on a bearing we can review the whole assembly. Quotes are prepared with the exact part number and the quantity you need.