DBH 9715/85 radial shaft seal — 23 x 35 x 6.5/7
- Brand
- DBH
- Category
- Seals
- Subcategory
- Radial shaft seals
We reply promptly.
Tell us the quantity you need and request a quote by WhatsApp or email.
Can't find the exact model? Tell us the part number or model you need. We'll track it down and quote it, whether or not it appears in our catalog.
Description
DBH 9715/85 belongs to radial shaft seal, part of our Seals range. Tell us how many you need by WhatsApp or email and we'll get back to you promptly with a quote for 9715/85 and any equivalents.
The DBH 9715/85 is a radial shaft lip seal built to keep lubricant inside a housing and keep dust, water and other contaminants out. It seats on a 23 mm shaft, presses into a 35 mm bore and measures 6.50/7.00 mm in height. Its A 219 design uses a single sealing lip with a steel spring, a configuration found throughout general industrial rotating equipment.
Reading the designation is straightforward: 23 mm is the shaft it runs on, 35 mm is the housing bore it presses into, and 6.50/7.00 mm is the height. The A 219 code describes the lip-and-spring construction. DBH is one of the seal lines MR supplies, so the part number is enough for us to identify what you need.
Typical service includes gearboxes, pumps, electric motors, compressors and power transmission drives. The same seal shows up in agricultural machinery, production lines and general plant equipment where grease or oil has to stay put and outside particles have to stay out. Because the cross-section is small, it also fits assemblies where space around the shaft is limited.
Before ordering, confirm that the shaft and bore match the seal designation. The shaft should be smooth, free of burrs and hard enough to avoid wearing the lip prematurely. Lubricate the lip before pressing the seal in and use a proper installation sleeve so the lip is not nicked or rolled. The 6.50/7.00 mm height gives a little room in the housing.
If your equipment calls for the same envelope but a different lip or material, send part number 9715/85 or the shaft, bore and height you measured. We can point you to an equivalent or a close variant from our seal range and advise on special applications.
Quotes are handled by WhatsApp or email. Include the part number and any relevant equipment details, and our team will get back to you with the information you need to complete the purchase.
Dimensions
- Shaft (d)
- 23mm
- Housing bore (D)
- 35mm
- Height (h)
- 6.50/7.00mm
- Design
- A 219
Frequently asked questions
- What size shaft and bore does the DBH 9715/85 fit?
- It runs on a 23 mm shaft and presses into a 35 mm housing bore, with a height of 6.50/7.00 mm. Those three figures come straight from the designation, so they are the first thing to check against your equipment.
- Where is this oil seal normally used?
- Rotating assemblies such as pumps, motors, gearboxes and compressors, plus agricultural machinery and production lines. Anywhere oil or grease must be retained and dust or water kept out, the A 219 lip-and-spring design is a common choice.
- How do I ask for a quote or a substitute?
- Send part number 9715/85 on WhatsApp or by email, or give us the shaft, bore and height you measured. Our team will confirm the seal or suggest an equivalent from the MR seal line.