DBH 9694Pol radial shaft seal — 37 x 60 x 12/30

DBH 9694Pol belongs to radial shaft seal, part of our Seals range. Tell us how many you need by WhatsApp or email and we'll get back to you promptly with a quote for 9694Pol and any equivalents.

A radial shaft seal from the DBH line, the 9694Pol closes the gap between a turning shaft and a fixed housing so lubricant stays in and dirt, water and fine particles stay out. It follows the A 289-R design, and its measurements are shaft 37 mm, housing 60 mm, width 12/30 mm. That combination suits power transmission assemblies and general industrial machinery where there is little room along the axis. MR Industrial Accessories LLC supplies this brand and helps buyers match the seal to the job.

Reading the code helps when you compare it with a drawing. The 9694Pol number identifies the item inside the DBH range, while A 289-R describes the lip profile and the case style used on rotating shafts that run with permanent lubrication. On size, the bore it seals against is 37 mm, the housing seat is 60 mm, and the width is given as 12.00/30.00 mm. That split width means a 12 mm body plus a further 30 mm section, so the same diameters can serve housings of different depths. Confirm all three values against the equipment drawing before you order.

You will find seals in this size range in gearboxes, pumps, electric motors, line shafts and process equipment that runs continuously. Agricultural machines, conveyors and hydraulic circuits also use them wherever oil or grease has to be held in and outside contamination kept away. Treat the seal as a wear part: at each preventive maintenance stop, look for the first signs of weeping and feel whether the lip has hardened. Equipment that runs hot or vibrates heavily calls for a lip compound suited to those conditions and checked against the fluid in use.

Correct selection starts with the three measurements taken from the old part. Shaft finish and tolerance matter as much as diameter, since scratches or oval wear speed up leakage. When fitting, coat the lip, press with a tool that will not cut or distort it, and make sure it enters the housing squarely. Fix burrs in the housing and shaft play before the new seal goes in. Our team can talk you through the A 289-R design and the variants that exist within it.

For an equivalent, send the code 9694Pol or the dimensions 37 x 60 x 12/30 mm by WhatsApp or email. A photo of the removed seal, the housing drawing or the marking on the part also works. With that information we look at options in the DBH line and among the other brands we carry, then confirm the closest match. MR Industrial Accessories LLC serves customers throughout the United States and in several Latin American countries.