DBH 9384 radial shaft seal — 47 x 68 x 8

DBH 9384 belongs to radial shaft seal, part of our Seals range. Tell us how many you need by WhatsApp or email and we'll get back to you promptly with a quote for 9384 and any equivalents.

The DBH 9384 is a single-lip radial shaft seal with a spring, sized for a 47 mm shaft, a 68 mm housing bore and an 8.00 mm height. It keeps lubricant in and contaminants out on rotating shafts, making it a common replacement part in gearboxes, pumps and medium-sized electric motors. MR supplies this seal and can help you confirm the right variant for your equipment.

The part number 9384 identifies a DBH seal in the Lx design, which means a single sealing lip with a spring for standard rotating-shaft service. The dimensions to check before ordering are shaft 47 mm, housing 68 mm and width 8.00 mm. Always compare these figures against the shaft and housing on your unit, since a seal that is even slightly off will not seat or seal correctly.

You will find this size in gear reducers, centrifugal pumps, electric motors and other power transmission equipment. Its job is to close the gap where the shaft passes through the housing, holding oil or grease inside and blocking dust, water and particles from entering. Because the lip runs against the shaft, the seal is a wear item: replace it when you see leakage or hear unusual noise at the sealing area.

Installation is straightforward but a few steps matter. Inspect the shaft for burrs, scratches or wear at the contact zone, and make sure the housing bore is clean and round. Lubricate the lip before pressing the seal in, and keep it perpendicular to the shaft, applying force evenly rather than striking the face. If the equipment runs at high peripheral speed or elevated temperature, contact MR to review the lip compound.

To quote a replacement or an equivalent, send the complete part number of the original seal, the shaft, housing and height dimensions, and a photo if possible. With that information we can search within the DBH line or in other brands we carry. We can also advise on lip type and case material based on the fluid and the working temperature of your application.

For a quote on the DBH 9384 seal, message the part number to MR Industrial Accessories via WhatsApp or email. If you are unsure about the designation, send the dimensions and we will help you identify it.