Skip to main content
All products
DBH type Lx radial shaft seal, double lip with one spring, in section · DBH 9375
DBH 9375 radial shaft seal — 45 x 85 x 10

DBHBrand We Carry

DBH 9375 radial shaft seal — 45 x 85 x 10

Manufacturer part number9375
Brand
DBH
Category
Seals
Get a quote for 9375 on WhatsApp

We reply promptly.

Tell us the quantity you need and request a quote by WhatsApp or email.

Can't find the exact model? Tell us the part number or model you need. We'll track it down and quote it, whether or not it appears in our catalog.

Ask on WhatsAppAsk by email

Description

DBH 9375 belongs to radial shaft seal, part of our Seals range. Tell us how many you need by WhatsApp or email and we'll get back to you promptly with a quote for 9375 and any equivalents.

A radial shaft seal from the DBH line, reference 9375, sized for a 45 mm shaft, an 85 mm bore and a 10 mm height. It presses into the housing and its lip rides against the rotating shaft, holding lubricant in and keeping dust and water out. Gearboxes, pumps and electric motors commonly use this size. MR Industrial Accessories supplies it within its seals and oil seals range.

The 9375 follows the Lx configuration: one sealing lip, an outer metal case and no exposed spring, which suits assemblies where axial room is tight. Read the three figures in this order: shaft 45 mm, housing 85 mm, height 10 mm. DBH is one of the brands MR carries, and 9375 is that brand's reference for this size.

You will find this seal in gearboxes, centrifugal pumps, electric motors, compressors and transmission equipment, always fitted in a cover or housing. Its job there is twofold: stop lubricant from escaping and keep contaminants away from the bearings. Treat it as a wear item, and plan to swap it once oil starts seeping or the lip feels hard or shows cracks.

Before pressing a new seal in, inspect the shaft for burrs, nicks or a wear groove, since any of these will damage the lip. Coat the lip with the same oil or grease the equipment runs on. Keep the seal square to the shaft and drive it in with a tube of matching diameter until it bottoms out in the housing. A shaft with visible wear may call for an offset lip instead. Speed, temperature and the fluid involved all factor into the final choice.

Send the code 9375 on WhatsApp and the team will quote it and suggest equivalents. If you are working from measurements rather than a code, share those instead, and ask about other sizes in the DBH line or seals from the other brands MR carries. The team helps you match the part to your equipment's dimensions, and replies promptly.

Dimensions

Shaft (d)
45mm
Housing bore (D)
85mm
Height (h)
10.00mm
Design
Lx

Frequently asked questions

What size is the DBH 9375 oil seal?
It fits a 45 mm shaft with an 85 mm housing bore and a 10 mm height. Confirm these three figures against your equipment before ordering.
Where is this seal typically used?
On rotating shafts in gearboxes, pumps, motors and compressors, where it retains oil or grease and blocks dust. It is replaced when leakage starts.
How do I ask for an equivalent size?
Message code 9375 on WhatsApp, or send your equipment's dimensions. The team will share options from the DBH line and other brands MR supplies.
Get a quote for 9375 on WhatsApp
Quote on WhatsApp