DBH 9347 radial shaft seal — 26 x 50 x 8

DBH 9347 belongs to radial shaft seal, part of our Seals range. Tell us how many you need by WhatsApp or email and we'll get back to you promptly with a quote for 9347 and any equivalents.

The DBH 9347 is a radial shaft seal sized for a 26 mm shaft, a 50 mm housing bore and an 8.00 mm height, built in the Lx design. It seats in the housing and its lip runs against the rotating shaft, keeping lubricant in and dirt, water and particles out.

Reading the code and dimensions: shaft 26 mm, housing 50 mm, height 8.00 mm. The Lx design is a single lip with a spring, made for lubricated rotating shafts. The elastomeric lip rides on the shaft while the metal case presses into the bore, holding the seal centered and firm.

This size shows up on gearboxes, pumps, electric motors, mixers, conveyors and other power transmission drives, as well as machine tools, compressors and hydraulic units where a shaft turns inside an oil-filled housing. The job is always the same: hold the oil in, keep contamination out. It costs little compared with the assembly it protects, yet a seal replaced on time avoids a great deal of unplanned downtime.

Selection starts with the three measurements matching the real shaft and bore. Then look at the running surface: a shaft that is worn, grooved or scratched will not let a new lip seat correctly. On installation, coat the lip with the same oil the equipment uses, keep it square to the shaft and never drive it in from the side. Tape or a cone over sharp edges and burrs protects the lip from cuts.

To quote part number 9347, send the dimensions of the old seal (shaft, housing and height), a photo of the part and the housing. With that we can look for an equivalent in DBH or another brand we supply. If Lx is not the right design for the service, speed and lubricant involved, we can point you to the correct variant.

For a quote on the DBH 9347, message us on WhatsApp or by email with part number 9347 or the dimensions 26 x 50 x 8 mm. If you need help with installation, or you are replacing a seal that already failed, send photos and we will help you pin down the right part.