DBH 9296 radial shaft seal — 48 x 62 x 7
- Brand
- DBH
- Category
- Seals
- Subcategory
- Radial shaft seals
We reply promptly.
Tell us the quantity you need and request a quote by WhatsApp or email.
Can't find the exact model? Tell us the part number or model you need. We'll track it down and quote it, whether or not it appears in our catalog.
Description
DBH 9296 belongs to radial shaft seal, part of our Seals range. Tell us how many you need by WhatsApp or email and we'll get back to you promptly with a quote for 9296 and any equivalents.
The DBH 9296 is a radial shaft seal built to sit on a rotating shaft and close against the housing bore, keeping lubricant where it belongs and keeping dust, water and particles out. You will find seals of this type in gearboxes, pumps, electric motors and power transmission equipment. MR Industrial Accessories supplies this brand and helps you match the seal to your shaft, housing and working conditions.
Read the designation first: DBH identifies the seal line and 9296 is the item reference. The three figures that matter for fitting are shaft 48.00 mm, housing 62.00 mm and height 7.00 mm. The Lx design means a single sealing lip with a spring, made for rotating shafts that run with lubrication. Shaft size is the figure most people start from, because the lip has to sit on the shaft raceway with a light interference fit, neither crushed nor loose.
Seals in this size range turn up in gearboxes, centrifugal pumps, electric motors, compressors and transmission units. The job is always the same: hold oil or grease in and keep contamination out. Because the section is only 7.00 mm, it also works well as a secondary closure on bearings and bushings where axial room is tight.
Before ordering, check that both the shaft and housing diameters on your equipment match the values listed. Look at the raceway as well: scratches or wear will stop the lip from sealing even when the size is right. When you install it, coat the lip with the same oil the equipment uses, press it in square to the shaft and do not hammer on it. If the seal runs under pressure or at elevated temperature, talk to us before substituting a different design.
For a quote, send the complete part number along with the shaft, housing and height measurements. With those figures we can search the lines we carry for a compatible alternative. We can also tell you whether the Lx design fits your application or whether a different lip type or material would be the better choice.
Send the part number for the DBH 9296 oil seal, or the size you need an equivalent for, by WhatsApp or email and the team will come back with the technical details and your quote.
Dimensions
- Shaft (d)
- 48mm
- Housing bore (D)
- 62mm
- Height (h)
- 7.00mm
- Design
- Lx
Frequently asked questions
- What are the dimensions of the DBH 9296 oil seal?
- Shaft 48.00 mm, housing 62.00 mm and height 7.00 mm. It is a radial shaft seal in the Lx design, with a single lip and spring.
- How do I know if this seal replaces the one I have installed?
- Check the three measurements against your equipment: shaft diameter, housing diameter and height. If they line up and the design suits the application, it will work. If you are unsure, send us the part number and the original dimensions.
- Can I request an equivalent size or one from another brand?
- Yes. Send the part number and the dimensions you need and we will look for a compatible option within the brands we carry. If your application calls for it, we can also review a different design.