DBH 9043 radial shaft seal — 14 x 24.05 x 8.5

DBH 9043 belongs to radial shaft seal, part of our Seals range. Tell us how many you need by WhatsApp or email and we'll get back to you promptly with a quote for 9043 and any equivalents.

The DBH 9043 is a radial shaft seal that keeps oil, grease or water from escaping between a rotating shaft and its housing. It fits a 14 mm shaft, a 24.05 mm housing bore and has an 8.50 mm height, with an Lx lip and body design. The seal is pressed into the housing and the lip runs against the shaft. As a wear part, it is replaced when leakage starts. MR Industrial Accessories supplies this seal.

This seal belongs to the DBH line and carries the code 9043. Its dimensions are shaft 14.00 mm, housing 24.05 mm and width 8.50 mm. The Lx designation describes the lip geometry and the metal case. It is a single-lip radial seal for rotating shafts that need lubrication retained inside the assembly. Before ordering, confirm that these three dimensions match your shaft and housing.

Seals of this size are common in small gearboxes, electric motors, pumps, compressors, fans and transmission units where a shaft turns inside a lubricated housing. They also appear in agricultural mechanisms, conveyor systems and process equipment. The job is always the same: stop lubricant from leaking out and keep dust, water and particles from entering and contaminating the lubricant or damaging the bearings.

When selecting or installing a seal, inspect the shaft first. If the lip has been running on the same track for a long time, a new shaft or a wear sleeve may be needed. The housing bore must be clean, free of burrs and at the correct diameter. During installation, lubricate the lip, press the seal in squarely without striking it, and make sure it seats completely. If the old seal failed, also check operating temperature, internal pressure and shaft alignment.

For an equivalent, send code 9043 along with your shaft and housing dimensions, or a drawing or photo of the old part. We will check the DBH line and compatible alternatives. If the Lx design does not suit your application, we can also advise on other lip and housing variants. The more details you provide, the faster we can identify the right part.

To request a quote for the DBH 9043 seal, contact MR Industrial Accessories via WhatsApp with the code and dimensions. We will reply with the corresponding reference and options in the seals and oil seals category.