DBH 9032 radial shaft seal — 10 x 20 x 7

DBH 9032 belongs to radial shaft seal, part of our Seals range. Tell us how many you need by WhatsApp or email and we'll get back to you promptly with a quote for 9032 and any equivalents.

The DBH 9032 is a radial shaft seal built for rotating shafts. It sits on the shaft and presses against the housing bore, holding lubricant in and keeping dust, water and other particles out. The dimensions are shaft 10 mm, housing 20 mm and height 7 mm. This Lx design is a single-lip seal with a spring, and you will find it in pumps, electric motors, gear reducers and power transmission equipment. MR supplies it as part of its seals and oil seals line for maintenance and replacement work.

The designation 9032 identifies this seal, and the three numbers you need to check before ordering are the shaft diameter of 10 mm, the housing bore of 20 mm and the height of 7 mm. The Lx code tells you it is a single-lip, spring-loaded seal for rotating shafts that run with lubrication. DBH is one of the brands MR carries. We confirm the part against the manufacturer's data sheet before sending a quote.

Seals in this size range show up in small centrifugal pumps, low-power electric motors, reducers, compressors, machine tools and power transmission equipment. In every case the job is the same: keep oil or grease inside the assembly and stop contaminants from getting in. Treat it as a wear part. It gets replaced on a preventive maintenance schedule or as soon as a leak becomes visible.

When you install a radial shaft seal, start by checking that the shaft and housing are clean and free of burrs or scratches. Lubricate the lip before you push the seal into place. Your selection should account for rotation speed, working temperature and the lubricant in use. If the equipment runs with high vibration or misalignment, another design may suit the application better. The Lx design fits general duty with a rotating shaft and continuous lubrication.

If you need an oil seal equivalent to the DBH 9032, send the part number 9032 or the dimensions 10 x 20 x 7 mm through WhatsApp. With that information we can locate an alternative from the same brand or from another manufacturer MR carries, keeping the shaft, housing and height dimensions unchanged. Variants with a different lip type or material are also available to inquire about, depending on the application.

To request a quote for the DBH 9032 oil seal or any of the seals and oil seals MR supplies, send the part number via WhatsApp. A technical advisor will reply with the quote and the alternatives that best fit your equipment.