DBH 8989 radial shaft seal — 95 x 125 x 12
- Brand
- DBH
- Category
- Seals
- Subcategory
- Radial shaft seals
We reply promptly.
Tell us the quantity you need and request a quote by WhatsApp or email.
Can't find the exact model? Tell us the part number or model you need. We'll track it down and quote it, whether or not it appears in our catalog.
Description
DBH 8989 belongs to radial shaft seal, part of our Seals range. Tell us how many you need by WhatsApp or email and we'll get back to you promptly with a quote for 8989 and any equivalents.
The DBH 8989 is a radial shaft seal built to hold lubricant in place around a rotating shaft while keeping dust and water out. With a 95 mm shaft, a 125 mm housing bore and a 12 mm height, it fits common rotating equipment such as gearboxes, pumps and electric motors. MR Industrial Accessories supplies this brand and helps you confirm the right seal for the job.
The part is listed under the designation 8989. Reading the size callout is straightforward: shaft 95 mm, housing 125 mm, width 12.00 mm. The Lx version is a single lip with a spring, so it retains grease or oil and blocks contaminants on a turning shaft. DBH covers seals for general industrial service, and this number matches a standard size that is simple to swap out.
You will find seals of this size in gear reducers, centrifugal pumps, electric motors, mixers and power transmission drives. In every case the seal sits in a fixed housing and rides on the rotating shaft, holding lubricant in and keeping outside matter out. Road and agricultural machinery also use them, since dust and moisture left unchecked will cut bearing life.
Proper installation starts with the shaft: check hardness and surface finish, and make sure there are no burrs or marks that could score the lip. The bore should be clean and undistorted, and the seal goes in with a sleeve that presses on the outer diameter, never on the lip. Lubricate the lip with the same oil or grease the equipment runs before seating it. If the shaft is worn, a wear sleeve is worth considering.
Looking for a match to the DBH 8989? Send the complete part number along with the shaft, housing and height measurements, plus a photo of the old seal if you have one. With that information we can search for an alternative in the same brand or another line we carry. We can also tell you whether the Lx design suits your application or whether a different lip type or material makes more sense.
To get a quote, send the part number through WhatsApp or email. Our team answers promptly and can suggest equivalents or help you choose.
Dimensions
- Shaft (d)
- 95mm
- Housing bore (D)
- 125mm
- Height (h)
- 12.00mm
- Design
- Lx
Frequently asked questions
- What size is the DBH 8989 oil seal?
- It takes a 95 mm shaft, a 125 mm housing bore and a 12.00 mm height. Those figures follow the standard designation, so the seal drops into equipment built for that dimensional combination.
- Where is this oil seal typically used?
- On rotating shafts in gearboxes, pumps, electric motors and general industrial machinery. It keeps lubricant inside and stops dust, water and particles from reaching the bearings.
- How do I ask for a quote or an equivalent?
- Send the part number 8989 and the dimensions of the seal you are replacing by WhatsApp or email. A photo of the old seal and the shaft, housing and height measurements help us offer the same item or a suitable alternative.