DBH 8808 radial shaft seal — 67 x 80 x 13

DBH 8808 belongs to radial shaft seal, part of our Seals range. Tell us how many you need by WhatsApp or email and we'll get back to you promptly with a quote for 8808 and any equivalents.

The DBH 8808 is a single-lip radial shaft seal built for a rotating shaft measuring 67 mm in diameter. It keeps lubricant where it belongs inside the housing and blocks dust, water and other contaminants from getting in. Installation is by press fit into a bore of 80 mm, and the seal stands 13 mm tall. Because it wears over time, it is normally swapped out during scheduled or breakdown maintenance.

In the DBH catalog, the reference 8808 points to this particular size. The seal follows an Lx configuration: an elastomer sealing lip combined with a steel spring. Shaft side, the lip runs against the rotating surface; outside, the outer diameter holds the press fit in the housing bore. Present the dimensions as shaft 67 mm, housing 80 mm, width 13.00 mm. For any piece of equipment running a 67 mm shaft with a matching bearing section, this is a standard off-the-shelf item.

Typical installations include centrifugal pumps, electric motors, gearboxes, mixers and transmission assemblies. You will also find it on agricultural machinery, conveyors and hydraulic circuits where a shaft turns inside an oil- or grease-filled crankcase. The Lx lip arrangement suits moderate running speeds and settings where dust or moisture is present. Keeping this part in good condition protects bearings and gears from premature wear.

Before fitting, confirm the shaft measures 67 mm and has suitable surface hardness with no burrs or scoring. The bore should be clean and machined to the 80 mm dimension within tolerance. Apply the same oil or grease used in the equipment to the lip before sliding the seal into place. Press evenly on the outer ring only, never on the lip. If the shaft surface is worn, look at a seal with an auxiliary lip or a repair sleeve. The 13.00 mm height has to match the housing depth.

If you are searching for a seal that matches the 8808, send the full code plus the shaft, bore and height measurements, along with a photo of the old part. That information lets us check alternatives across other brands and series. We can also tell you whether the original unit carries a special feature such as a double lip or a specific elastomer. MR Industrial Accessories supplies the DBH brand.

To get a quote on the DBH 8808 or to ask about a different size, message us on WhatsApp. Include the code and dimensions, and we will get back to you promptly. Our team can also help you identify the correct part for your equipment. We manufacture split plummer block housings, roller chains and sheaves in-house, and we serve customers throughout the United States and in several Latin American countries.