DBH 8758 radial shaft seal — 160 x 200 x 12

DBH 8758 belongs to radial shaft seal, part of our Seals range. Tell us how many you need by WhatsApp or email and we'll get back to you promptly with a quote for 8758 and any equivalents.

The DBH 8758 is a radial shaft seal designed to keep lubricant in and contaminants out of rotating equipment. It fits a 160 mm shaft, a 200 mm housing, and has a 12.00 mm height, with the Lx lip design. MR Industrial Accessories supplies this seal and helps you verify the dimensions before you order.

This seal belongs to the DBH line and carries the code 8758. Its key measurements are shaft diameter 160 mm, housing diameter 200 mm, and height 12.00 mm. The Lx designation refers to the lip geometry and overall shape. These figures come from the manufacturer's data sheet; always compare them with your actual shaft and housing before installation.

Seals of this size are common in gearboxes, pumps, mixers, mills, conveyors, and other process machinery. Their job is to retain oil or grease and limit the ingress of dust, water, or particles. Because it is a wear part, watch for lubricant leaks or unusual noise near the bearing and replace the seal when needed.

During installation, check that the shaft is free of burrs or scratches and that the housing is clean and undistorted. Lubricate the lip, then press the seal in squarely with a flat driver to avoid damage. Selection depends on shaft speed, operating temperature, and the fluid being sealed. If any of these are unclear, contact us and we can review them with you. Never force a seal that does not fit properly; a misaligned lip will not seal effectively.

If you need a different size or an alternative, we can source an equivalent radial shaft seal. Provide the shaft diameter, housing diameter, and height you measured, plus a photo of the old part if possible. With that information, we can identify suitable options for your equipment.