DBH 8752 radial shaft seal — 55 x 72 x 10

DBH 8752 belongs to radial shaft seal, part of our Seals range. Tell us how many you need by WhatsApp or email and we'll get back to you promptly with a quote for 8752 and any equivalents.

The DBH 8752 is a radial shaft seal with an Mx design, a single lip with a spring, made to sit in the housing and seal against a rotating shaft. It keeps lubricant in and contaminants out, and it is a common replacement item on gearboxes, pumps and transmission equipment. The dimensions are 55.00 mm for the shaft, 72.00 mm for the housing and 10.00 mm for the height. MR Industrial Accessories supplies it within its seals and oil seals range.

You identify this seal by the designation 8752. In the Mx configuration, a single lip with a spring runs against the shaft, which is the usual setup for lubricated rotating equipment. The three dimensions to check before ordering are shaft 55.00 mm, housing 72.00 mm and height 10.00 mm.

These seals are found in gearboxes, centrifugal pumps, electric motors, mixers and conveyors, as well as in agricultural and industrial machinery where the shaft turns continuously and dust or moisture is present. They protect bearings and gears from oil or grease loss. Because the lip is a wear surface, hardening or marking leads to leakage, so replacing the seal early helps avoid damage to the bearing.

During installation, confirm the shaft is clean and free of burrs or scratches, with a surface finish appropriate for a radial shaft seal. Apply lubricant to the lip, then press the seal in squarely, keeping it perpendicular to the shaft and avoiding side impacts. A chamfered housing helps keep the lip from folding over. For selection, consider shaft speed, operating temperature and the fluid being retained, since those factors determine the elastomer compound.

If you need an equivalent, send the part number 8752 or the dimensions 55 x 72 x 10 mm along with the application details. We can suggest options in other brands or configurations from the same radial shaft seal category. Providing speed, temperature, fluid and shaft type helps us give you a more accurate proposal, and we can also confirm the equivalent standard size in the DBH line.

To request a quote for the DBH 8752 oil seal, message the part number to MR Industrial Accessories on WhatsApp or by email. We respond with the quote and, if this is not the exact size, with alternatives. Our team works with the brands we carry and can guide you through the seals and oil seals selection.