DBH 8245 radial shaft seal — 13 x 27 x 5
- Brand
- DBH
- Category
- Seals
- Subcategory
- Radial shaft seals
We reply promptly.
Tell us the quantity you need and request a quote by WhatsApp or email.
Can't find the exact model? Tell us the part number or model you need. We'll track it down and quote it, whether or not it appears in our catalog.
Description
DBH 8245 belongs to radial shaft seal, part of our Seals range. Tell us how many you need by WhatsApp or email and we'll get back to you promptly with a quote for 8245 and any equivalents.
The DBH 8245 is a radial shaft seal that keeps oil, grease or water from escaping between a rotating shaft and its housing. It fits a 13 mm shaft, a 27 mm bore and a 5 mm width, making it a common wear part in gearboxes, pumps, electric motors and power transmission equipment. When lubricant starts to seep or the lip hardens, the seal is replaced.
This seal uses the Lt design, a single lip with a spring for rotating shafts that run with lubrication. The sealing lip rides on the shaft while the outer diameter presses into the housing bore. Check the shaft for burrs or scratches before installation; any mark can cut the lip and cause a leak.
You will find a seal of this size in small gearboxes, water and oil pumps, low-power motors, gear reducers and other transmission components. It also shows up in machine tools and process equipment where a lubricated area must stay separate from dust or moisture. In all cases, the job is the same: hold lubricant in and keep contaminants out.
Selection starts with confirming three measurements: shaft 13 mm, housing 27 mm and width 5.00 mm. Then inspect the shaft surface. A worn shaft or a visible groove will prevent the new lip from sealing correctly, so consider a repair sleeve or a seal with an offset lip. During mounting, lubricate the lip, align the seal squarely and press it in with a tube or socket that matches the outer diameter.
To request a quote for part number 8245, send the part number and the dimensions by WhatsApp or email. If you need an equivalent from another brand, share the shaft, housing and width dimensions and we will look for alternatives in the DBH seal line or from other brands we carry. We can also advise if the Lt design is not the best fit for your application.
When you contact us, include the quantity you need. If you are unsure about the size or design, attach a photo of the old seal or the measurements taken with a caliper. That helps us confirm the match before preparing your quote.
Dimensions
- Shaft (d)
- 13mm
- Housing bore (D)
- 27mm
- Height (h)
- 5.00mm
- Design
- Lt
Frequently asked questions
- What are the dimensions of the DBH 8245 seal?
- It has a 13 mm shaft diameter, a 27 mm housing diameter and a 5.00 mm height, with Lt design. Verify these against your shaft and bore before ordering.
- How can I tell if this seal will replace the one I have?
- Measure the shaft, housing and height of the old seal with a caliper. If they match 13, 27 and 5.00 mm, the DBH 8245 is a candidate. If the shaft is worn, check with us first.
- Can I request a different size or an equivalent?
- Yes. Send part number 8245 and the dimensions you need by WhatsApp or email. We will look for an equivalent from another brand we carry and send you a quote.