DBH 6807 radial shaft seal — 36 x 54 x 8/11
- Brand
- DBH
- Category
- Seals
- Subcategory
- Radial shaft seals
We reply promptly.
Tell us the quantity you need and request a quote by WhatsApp or email.
Can't find the exact model? Tell us the part number or model you need. We'll track it down and quote it, whether or not it appears in our catalog.
Description
DBH 6807 belongs to radial shaft seal, part of our Seals range. Tell us how many you need by WhatsApp or email and we'll get back to you promptly with a quote for 6807 and any equivalents.
The DBH 6807 is a single-lip radial shaft seal used to keep lubricant in and contaminants out of rotating equipment. Its A 030 design and stepped height of 8/11 mm let it sit in housings with a shoulder or in covers that need a lip with more coverage. It is a common choice for pumps, electric motors, gearboxes and transmission units where the shaft turns continuously.
This seal carries the code DBH 6807. The dimensions are shaft 36 mm, housing 54 mm, and height 8.00/11.00 mm. The A 030 design is a single-lip seal with a spring, intended for rotating shafts under permanent lubrication. Because the height is stepped from 8 to 11 mm, the body has a shoulder that can seat in a cavity with a recess, which helps with retention and centering in the housing.
You will find this seal in centrifugal pumps, electric motors, speed reducers, gearboxes and power transmission equipment. In each case it holds oil or grease in place and keeps dust, water and particles away from bearings and gears. Its compact size suits equipment with limited shaft space where dependable, low-maintenance sealing is required.
For correct installation, check that the shaft has the right hardness and surface finish and that the housing is clean and free of burrs. Lubricate the lip with the same oil or grease used in the equipment, then press it in evenly until it seats at the bottom. If the shaft shows wear, a seal with an auxiliary lip may be a better fit. Final selection depends on the speed, temperature and lubricant of the equipment.
If you are looking for an equivalent, send the code 6807 with the shaft and housing dimensions. A photo of the part or the drawing also helps us find the alternative that matches your application. We can advise on the most suitable design.
To request a quote for the DBH 6807 seal or ask about other sizes, contact us on WhatsApp or by email. We will reply with replacement options and help you choose the correct seal.
Dimensions
- Shaft (d)
- 36mm
- Housing bore (D)
- 54mm
- Height (h)
- 8.00/11.00mm
- Design
- A 030
Frequently asked questions
- What are the dimensions of the DBH 6807 seal?
- The DBH 6807 seal has a shaft diameter of 36 mm, a housing diameter of 54 mm and a height of 8.00/11.00 mm. These dimensions correspond to the A 030 design, with a single lip and spring.
- Where is this seal typically used?
- It is used on rotating shafts of pumps, electric motors, reducers and gearboxes. Its function is to retain lubricant and prevent the entry of dust or water, protecting internal components.
- How do I request a quote or an equivalent?
- Write to us on WhatsApp or email with the code 6807 and the shaft and housing dimensions. You can also send a photo or drawing so we can look for the best alternative.