DBH 6560 radial shaft seal — 90 x 126.95 x 15.8

DBH 6560 belongs to radial shaft seal, part of our Seals range. Tell us how many you need by WhatsApp or email and we'll get back to you promptly with a quote for 6560 and any equivalents.

The DBH 6560 is a radial shaft lip seal built to hold lubricant in and keep contaminants out where a shaft rotates. Its three key measurements are a 90 mm shaft, a 126.95 mm housing bore and a 15.80 mm height, and it carries the Lx design, meaning a single lip with a spring. You will find seals of this type in gearboxes, pumps, motors and other rotating equipment, and MR Industrial Accessories LLC supplies this brand and helps you confirm the right choice for your machine.

The part number 6560 belongs to the DBH line of radial shaft seals. Read the size code as shaft 90 mm, bore 126.95 mm, height 15.80 mm, and treat the Lx designation as a single-lip, spring-loaded profile intended for lubricated rotating shafts. The elastomer body works together with the internal spring to keep the sealing edge in contact with the shaft, which is what makes the seal effective during continuous running. This is a defined replacement part rather than a generic item, so the dimensions on the data sheet should be matched before installation.

Seals in this size range show up in gearboxes, centrifugal pumps, electric motors, reducers and power transmission assemblies. In each case the job is the same: stop oil or grease from escaping and keep dust, water and particles from getting in. Because of its dimensions, this seal fits medium and larger equipment. Where the original unit calls for a seal of these measurements, the DBH 6560 is a replacement option within the range MR supplies.

Proper installation starts with the shaft and housing. Check that the shaft has the right hardness and surface finish, and that the bore is clean with no burrs. Before pressing the seal in, coat the lip with the same oil the equipment uses. Always select by the measured shaft and bore, not by the part number alone. If anything is unclear, our team can help you confirm fit and pick a lip material suited to your operating temperature and fluid.

If you are looking for an equivalent, the fastest route is to send the number 6560 or the exact shaft and bore dimensions. A photo of the old seal or the equipment data sheet also works. MR Industrial Accessories LLC checks the alternative against the brands it supplies and returns a quote. Dimensions are cross-checked against the manufacturer's data sheet before any solution is offered.

To get started, message us on WhatsApp or by email with the part number DBH 6560 or your seal dimensions. We reply promptly with the option that fits your equipment, and we can suggest equivalents and help you choose.