DBH 6455 radial shaft seal — 57.15 x 76.17 x 17.06

DBH 6455 belongs to radial shaft seal, part of our Seals range. Tell us how many you need by WhatsApp or email and we'll get back to you promptly with a quote for 6455 and any equivalents.

The DBH 6455 is a radial shaft seal built to keep lubricant in and contaminants out. It fits a 57.15 mm shaft and a 76.17 mm housing bore, with a height of 17.06 mm. The Lx configuration uses a single lip with a spring, making it suitable for rotating shafts. This seal is part of the sealing line available through MR Industrial Accessories LLC.

This seal carries part number 6455 and is identified by its three key dimensions: shaft 57.15 mm, housing 76.17 mm, and width 17.06 mm. The outer diameter presses into the housing, while the inner lip rides on the shaft. The spring helps maintain lip contact as the seal wears. It is a direct replacement for equipment already using this size.

A seal of this size commonly appears in gearboxes, pumps, motors, and conveyor rollers. It works wherever a shaft rotates inside a housing and oil or grease must stay separated from the outside. By keeping dust and moisture away from bearings, it supports longer service life in harsh conditions.

Before installation, clean the shaft and housing bore and remove any burrs. Apply a light film of the equipment's lubricant to the seal lip. Press the seal in evenly, using a tool that contacts only the outer diameter. If the shaft shows a wear groove, a repair sleeve may be needed. The right choice depends on shaft speed, temperature, and lubricant type.

To request a quote, send part number 6455 and the required quantity via WhatsApp or email. If you are unsure about compatibility, include the shaft and housing measurements or a photo of the old seal. The team at MR Industrial Accessories LLC can check the data and suggest alternatives within the same series or with equivalent dimensions.