DBH 6113 radial shaft seal

DBH 6113 belongs to radial shaft seal, part of our Seals range. Tell us how many you need by WhatsApp or email and we'll get back to you promptly with a quote for 6113 and any equivalents.

The DBH 6113 is a single lip radial shaft seal built for a 60.33 mm shaft with a 12.70 mm overall height. It keeps oil or grease where it belongs and blocks dust, water and particles from reaching the bearing or bushing behind it. Where axial room is tight and leaks cannot be tolerated, this is the type of seal that does the job.

The seal carries the designation 6113 and sits in the DBH radial shaft seal line, with design A 086. Reading the data: shaft 60.33 mm, height 12.70 mm. The lip runs against a rotating shaft, so the shaft surface has to be ground and held to a controlled finish for the seal to work as intended.

Typical installations include gearboxes, pumps, electric motors, transmission shafts and process equipment. In plants with dust, humidity or regular washdowns, the seal is what separates the lubricant from everything outside the housing. Maintenance teams also fit it as a replacement when a small leak shows up or when a unit is opened for inspection.

Selection comes down to three checks: shaft diameter, housing height and lip type. The shaft should be smooth and free of grooves, since a rough or worn surface wears the lip faster. At assembly, coat the lip with the same grease or oil used in service, seat the seal square to the shaft, and drive it in with a tube or spacer that presses on the outer ring rather than striking the seal directly. Any burrs in the housing should be removed first.

If you are looking for a cross-reference, send code 6113 together with the shaft and housing dimensions, or a photo of the old seal or the assembly drawing. The data is checked against the manufacturer's sheet so the alternative you receive does the same job without any change to the housing.

For a quote on the DBH 6113, or to ask about other sizes in the line, message us on WhatsApp with the code. You will get back the options and the technical data your application needs.