DBH 6092 radial shaft seal — 130 x 170 x 15

DBH 6092 belongs to radial shaft seal, part of our Seals range. Tell us how many you need by WhatsApp or email and we'll get back to you promptly with a quote for 6092 and any equivalents.

Part number 6092 belongs to the DBH line of radial shaft seals. It is a lip seal: it sits on the shaft and closes against the housing bore, holding lubricant in and keeping dust, water and particles out. The size is given as shaft 130 mm, housing 170 mm and height 15.00 mm, with an Lz design that sets how the lip and body are built. Equipment running shafts of this diameter, such as gearboxes, pumps, motors and power transmission drives, is where this seal is normally found. MR Industrial Accessories supplies this brand and quotes it on request.

Reading the reference is simple: 6092 is the part number, and the three figures that follow describe the bore it fits. Shaft 130 mm, housing 170 mm, width 15.00 mm. The Lz designation tells you the lip and body arrangement, so it is worth confirming that the seal you pull out of the machine carries the same designation before you order. This is a thin-section seal, made for machined housings and shafts held to controlled tolerance, so a seal from a different size range will not seat or seal the way it should.

Seals of this size turn up wherever a rotating shaft leaves a lubricated housing: gearboxes, centrifugal pumps, electric motors, mixers, conveyors and other process machinery. The job is always the same one, keeping oil or grease where it belongs and shutting out the contaminants that shorten bearing and gear life. In housings where the pressure inside differs from the pressure outside, the seal also acts as the closure.

Selection starts with the shaft. Look for burrs, deep wear marks and the surface finish in the area the lip contacts, and check that the housing bore is clean, round and free of dents. Fit the seal with the lip lubricated and guide it in with a tool that keeps it square, so the lip does not roll or tear. If the shaft already shows a groove or visible wear, repair it or move to a different shaft size before pressing a new seal into place.

For a cross-reference, send part number 6092 or the shaft, housing and height measurements taken from the equipment. With that we can search the DBH line or another brand we carry. It also helps to note the lubricant type, the rotation speed and the operating temperature, since those three points weigh on the choice of lip material.

MR Industrial Accessories supplies the DBH brand. To request a quote for the DBH 6092 oil seal, message us on WhatsApp or by email with the part number, or with the shaft, housing and height dimensions. We reply promptly, suggest equivalents and help you confirm the right choice.