DBH 6049 radial shaft seal — 106.36 x 126.95 x 12.7

DBH 6049 belongs to radial shaft seal, part of our Seals range. Tell us how many you need by WhatsApp or email and we'll get back to you promptly with a quote for 6049 and any equivalents.

The DBH 6049 is a radial shaft seal built to hold lubricant in place and keep dust, water and particles out of rotating assemblies. It fits a 106.36 mm shaft, a 126.95 mm housing bore and a 12.70 mm height, which puts it close to a 4 inch nominal shaft. MR Industrial Accessories supplies this brand and helps you match the right oil seal to your equipment.

The item is identified by designation 6049, and the three figures you need before ordering are shaft 106.36 mm, housing 126.95 mm and height 12.70 mm. The Lz design refers to a single lip with a spring, made for rotating shafts. Check these values against the actual shaft and bore, because even a small difference changes how the seal seats and performs.

You will find seals like this one in gearboxes, pumps, electric motors, rollers and power transmission equipment. Two jobs are done at once: the oil or grease stays inside the assembly, and outside contamination stays out. Common locations in a plant include fan shafts, mixers and conveyors, where the seal runs against constant friction.

Selection comes down to the three dimensions plus the design. With Lz, the spring keeps the lip in steady contact with the shaft. The shaft surface should be ground and free of burrs, and the housing needs a proper chamfer so the lip is not cut during installation. Lubricating the lip beforehand and using the correct installation tool both help the seal last.

If you need the same dimensions in a different design, or a nearby variant, send the code 6049 or the shaft, housing and height you measured. We can look at alternatives in the same brand and in the other lines we carry, and we will tell you if Lz is not the best fit for your application.

To get a quote, message the code on WhatsApp or by email. We answer promptly and can also identify the correct replacement from a sample or from dimensions taken on the machine.