DBH 6010 radial shaft seal — 60.33 x 88.9 x 11.11

DBH 6010 belongs to radial shaft seal, part of our Seals range. Tell us how many you need by WhatsApp or email and we'll get back to you promptly with a quote for 6010 and any equivalents.

The DBH 6010 is a radial shaft seal, also called a lip seal, built for rotating shafts. It keeps lubricant where it belongs and blocks dust, water and particles from reaching the bearing cavity. The three figures that identify it are shaft 60.33 mm, housing 88.90 mm and width 11.11 mm, and it carries the Mz design. MR supplies this brand and helps you match the right seal to your equipment.

Reading the designation is straightforward. DBH names the seal family, 6010 is the item number, and the three measurements follow the usual order: the shaft it rides on, the bore it presses into, and its width. On this part those are 60.33 mm, 88.90 mm and 11.11 mm. The Mz design refers to the lip and cross-section geometry, which is what lets the seal follow a turning shaft. The elastomeric lip, commonly NBR, handles oils and greases, while the metal outer case holds the seal firmly in the housing.

You will find this seal on gearboxes, pumps, electric motors and transmission shafts. Plants in food, chemical and process work rely on it to contain lubricant and keep outside matter out, and it also shows up on agricultural and road machinery where dust and moisture are constant. The Mz design suits moderate peripheral speeds and low pressures, as long as shaft and housing tolerances are held.

Good installation decides how long the seal lasts. Check the shaft for hardness and surface finish, and remove any burrs or marks that could score the lip. Coat the lip with the same oil or grease the equipment runs on, then press the seal in with a tool that loads the outer circumference evenly. The housing should be clean and undistorted. When you pick a seal, weigh rotation speed, operating temperature and the fluid being retained.

If you need the same dimensions from another brand or series, or a variant in a different material such as Viton (FKM) or polyurethane for tougher conditions, we can look for it. Have the part number DBH-6010 or the designation 6010 ready along with the measurements of the seal you are replacing, and our team will review the request and come back with compatible options.