DBH 5844 radial shaft seal — 69.85 x 95.5 x 19.05

DBH 5844 belongs to radial shaft seal, part of our Seals range. Tell us how many you need by WhatsApp or email and we'll get back to you promptly with a quote for 5844 and any equivalents.

When a rotating shaft passes through a housing, the DBH 5844 radial shaft seal keeps oil or grease where it belongs and blocks contaminants from entering. Its three key measurements are shaft 69.85 mm, housing 95.50 mm and width 19.05 mm, and it is built to design A 157. Because the lip wears against the shaft over time, the seal is a replacement item: once lubricant starts escaping or dirt works its way in, it should be swapped out. MR Industrial Accessories supplies this brand and can help you confirm the right size.

The DBH line identifies this seal with the code 5844. It is a single-section radial shaft seal: an elastomeric lip bonded to a sheet metal case, pressed into the housing so the lip runs against the shaft. Design A 157 describes the lip and case geometry. Before installation, always measure the shaft, housing bore and width to confirm they match the values above.

You will find this type of seal in gearboxes, pumps, electric motors, drive shafts, rollers and process machinery, as well as in agricultural and industrial equipment where shaft speed is moderate and temperatures stay within normal ranges. In every case the job is the same: retain lubricant and exclude dust or water, which helps protect the bearing or bushing riding on that shaft.

Selection starts with the three dimensions and the design. Inspect the shaft surface as well; scratches, wear or burrs will prevent the lip from sealing, so repair the shaft or fit a sleeve if needed. During installation, apply lubricant to the lip, press the seal in perpendicular to the shaft using a tube or press that bears on the outer edge, and never strike it with a hammer. If the old seal carries a different code, compare dimensions and design before substituting.

To request a quote for the 5844, send the code, the shaft, housing and width measurements, and a photo of the old seal. Our team can cross-reference the equivalent in the same brand or another line we carry, and check design A 157 against the manufacturer's data to confirm the lip and case geometry suit your equipment.

MR Industrial Accessories stocks the DBH brand. For a quote on this seal, message us on WhatsApp or email with the code 5844 and we will respond with the option that fits your application.