DBH 5662 radial shaft seal — 76.2 x 95.28 x 12.7

DBH 5662 belongs to radial shaft seal, part of our Seals range. Tell us how many you need by WhatsApp or email and we'll get back to you promptly with a quote for 5662 and any equivalents.

The DBH 5662 is a radial shaft seal built for rotating shafts that need reliable lubricant retention and protection against external contamination. Its Mz configuration uses a single sealing lip with a spring to maintain contact with the shaft. This model fits housings of 95.28 mm and shafts of 76.2 mm, with a height of 12.70 mm.

Part number 5662 belongs to the DBH line of radial shaft seals. The key dimensions to verify before ordering are: shaft diameter 76.2 mm, housing bore 95.28 mm, and width 12.70 mm. The Mz design indicates a metal outer case and a spring-loaded elastomer lip, which presses against the shaft to keep oil or grease inside while keeping dust and moisture out.

This seal works in gearboxes, pumps, motors, and other power transmission equipment. Because it is a wear item, the lip eventually loses its effectiveness and the seal must be replaced. Checking the seal during routine maintenance helps prevent bearing failure from lubricant loss or contamination.

When installing the DBH 5662, make sure the shaft and housing are clean and free of burrs. Apply a light coat of the equipment's lubricant to the lip before pressing the seal into place. Use a proper installation tool to keep the seal square and avoid damaging the lip. If the shaft shows a groove from the old seal, consider a repair sleeve or a seal with a different lip position.

For a quote or help selecting an equivalent, send the part number 5662 or the exact dimensions to our team via WhatsApp or email. We can suggest alternatives with similar size or different lip materials for specific operating conditions.

MR supplies the DBH brand as part of its seals and oil seals range. Our team is available to answer technical questions and provide a prompt quotation.