DBH 5600 radial shaft seal — 30.1 x 47.62 x 6.35

DBH 5600 belongs to radial shaft seal, part of our Seals range. Tell us how many you need by WhatsApp or email and we'll get back to you promptly with a quote for 5600 and any equivalents.

The DBH 5600 is a radial shaft seal built to keep lubricant in and contaminants out where a shaft rotates. With a 30.10 mm shaft diameter, a 47.62 mm housing diameter and a 6.35 mm height, it fits equipment where space is tight. The Mz design uses a rubber lip with a spring and no outer metal case, so it seats directly in a machined housing. You will find it in pumps, electric motors, gear reducers and transmissions, where it helps bearings and gears last longer.

This seal carries the DBH brand and part number 5600. Its three key dimensions are the shaft diameter (d) at 30.10 mm, the housing diameter (D) at 47.62 mm and the overall height (h) at 6.35 mm. The Mz designation tells you the seal has a lip and spring but no metal outer case, meaning it mounts straight into the housing bore. Those dimensions make it a direct replacement for worn seals in spots where axial room is limited and you still need a reliable barrier against dust, water and oil loss.

You will typically see this seal in centrifugal pumps, electric motors, gear reducers, transmission boxes and process equipment. In each case it shields bearings and gears from outside contamination and stops lubricant from escaping. It shows up in industrial machinery, agricultural equipment and pumping systems where shafts turn at moderate speeds and the working conditions call for dependable sealing over time.

When installing, check that the shaft and housing diameters match the figures above. The Mz design needs a machined housing with a suitable surface finish and a tolerance that holds the fit. Lubricate the lip before fitting it, using the same oil or grease that runs in the equipment, and inspect the shaft for burrs or marks that could harm the seal. Your selection should also account for rotation speed, temperature and the fluid being retained.

If you need a seal with the same dimensions or a close variant, send us part number 5600 or the measurements of your shaft and housing. At MR Industrial Accessories we can help you find the right replacement from our line of seals and radial shaft seals. We can also point you to alternatives from other brands or configurations when the Mz design does not fit your application.

To request a quote for the DBH 5600 seal, message the part number to MR Industrial Accessories on WhatsApp. If you are unsure about compatibility, send the shaft and housing dimensions and we will help you confirm this model is correct for your equipment.