DBH 5484 radial shaft seal — 19 x 33.22 x 9.5

DBH 5484 belongs to radial shaft seal, part of our Seals range. Tell us how many you need by WhatsApp or email and we'll get back to you promptly with a quote for 5484 and any equivalents.

When a rotating shaft needs a dependable barrier against lubricant loss and outside contamination, the DBH 5484 radial shaft seal fits the job. It is built with a 19 mm shaft diameter, a 33.22 mm housing diameter and a 9.50 mm overall height, and its Lx design identifies a single lip with a spring. MR Industrial Accessories supplies this seal and can help you confirm it matches your equipment before you order.

The 5484 part number belongs to the DBH line of radial shaft seals. Reading the size callout is straightforward: the shaft measures 19 mm, the housing bore measures 33.22 mm and the seal is 9.50 mm tall. The Lx designation tells you the seal has one lip with a spring, which is a common setup for lubricated rotating shafts. The elastomeric lip rides against the shaft while the outer diameter stays fixed in the housing, so the assembly keeps oil or grease where it belongs. As a wear item, this seal shields bearings, bushings and gears from premature damage.

You will find seals like the DBH 5484 in gearboxes, pumps, electric motors, compressors, fans and other transmission equipment. Their job is two-way: hold lubricant inside and keep dirt, water and chips out. On shafts that turn at moderate speed and operate within the normal temperature range for elastomers, this type of seal helps bearings last longer and cuts unplanned downtime. Agricultural machinery, transport equipment and general industrial drives are also common places to find it.

Installation calls for a few simple checks. Look for burrs or wear on the shaft, and make sure the housing is clean and not distorted. Coat the lip with the same oil or grease used in the equipment, then press the seal in evenly without striking the lip. If the shaft shows a worn groove, you can reposition the seal slightly or replace the shaft. Choosing the right seal depends on speed, temperature, the fluid involved and any differential pressure; the Lx design suits standard lubricated applications where pressure is not high.

If you are looking for a replacement for the DBH 5484, send the full part number, the shaft, housing and height dimensions, and a photo of the original seal. With those details we can search for a compatible option among the brands we carry or propose a seal with close dimensions that works with your machining. We can also advise on lip type and material based on the fluid and operating temperature.

To request a quote for the DBH 5484 oil seal or a substitute, message part number 5484 to MR Industrial Accessories on WhatsApp. We will come back with the compatible choices. If you are unsure about installation or selection, our team can help you pin down the right seal for your equipment. We also assist with oil seals, bearings, housings and power transmission parts.