DBH 5453 radial shaft seal — 60 x 95 x 13
- Brand
- DBH
- Category
- Seals
- Subcategory
- Radial shaft seals
We reply promptly.
Tell us the quantity you need and request a quote by WhatsApp or email.
Can't find the exact model? Tell us the part number or model you need. We'll track it down and quote it, whether or not it appears in our catalog.
Description
DBH 5453 belongs to radial shaft seal, part of our Seals range. Tell us how many you need by WhatsApp or email and we'll get back to you promptly with a quote for 5453 and any equivalents.
The DBH 5453 is a radial shaft lip seal that blocks lubricant from escaping between a rotating shaft and its stationary housing. It suits a 60 mm shaft, a 95 mm housing bore and a 13 mm cavity height, and uses the Lx configuration. MR Industrial Accessories supplies this brand and can help you verify the size before you request a quote.
Part number 5453 belongs to the DBH line of radial shaft seals. The dimensions are shaft 60.00 mm, housing bore 95.00 mm and height 13.00 mm. The Lx design means a metal-cased seal with a single sealing lip, built to hold grease or oil in and keep dust and moisture out along a rotating shaft. Because the lip is a wear item, hardening or visible marks on it will lead to leakage and replacement becomes necessary.
Seals in this size range are common in gearboxes, centrifugal pumps, electric motors, rollers and power transmission equipment. In each case the lip runs against the shaft while the outer case stays fixed in the housing. Where dust, chips or water are present, the same lip also acts as an excluder, shielding bearings and lubricant from contamination.
For a correct installation, confirm that the shaft measures 60 mm, the housing bore 95 mm and the cavity width 13 mm. Inspect the shaft for burrs or wear in the lip contact zone, coat the lip with lubricant before sliding it into place and press the seal in squarely without tilting. A scratched shaft raceway can prevent even a new seal from sealing, so check that surface as well.
If 5453 is not the right number, or if your assembly uses different dimensions, send the measured shaft diameter, housing bore and cavity width. Using those values we can locate an equivalent in the same DBH line. We can also help you choose the lip type and material based on the fluid and the operating temperature.
MR Industrial Accessories supplies the DBH brand. To confirm that this 5453 seal fits your equipment, send the part number or your measurements by WhatsApp or email and the team will reply with a quote. If you need a size other than the one listed here, we can also review alternatives.
Dimensions
- Shaft (d)
- 60mm
- Housing bore (D)
- 95mm
- Height (h)
- 13.00mm
- Design
- Lx
Frequently asked questions
- How do I know if this seal replaces the one I have installed?
- Check the shaft diameter, housing bore and cavity width against the 60 x 95 x 13 mm of the 5453. If the shaft is worn where the lip runs, a new seal may not seal. Send us the dimensions on WhatsApp and we will verify it.
- Can I request a size different from the 5453?
- Yes. If your shaft or housing has a different size, send us the actual diameters and the cavity width. With that data we look for an equivalent within the DBH line and quote you on WhatsApp.
- What are the dimensions of the DBH 5453 seal?
- The DBH 5453 seal has a 60.00 mm shaft diameter, a 95.00 mm housing bore diameter and a 13.00 mm height. The design is Lx. Before ordering, measure the shaft and housing with a caliper to make sure they match those values.