DBH 5410 radial shaft seal — 32 x 44 x 7

DBH 5410 belongs to radial shaft seal, part of our Seals range. Tell us how many you need by WhatsApp or email and we'll get back to you promptly with a quote for 5410 and any equivalents.

The DBH 5410 is a radial shaft seal in an Lx design, a single-lip profile with a spring for rotating shafts that run with lubrication. It keeps oil or grease inside the assembly and blocks dust, water and particles from getting in. The dimensions are 32 mm for the shaft, 44 mm for the housing bore and 7.00 mm for the height, which places it in gearboxes, pumps, electric motors and power transmission equipment. MR Industrial Accessories supplies this brand and can help you match the seal to your shaft and housing.

The 5410 code identifies the size combination within the DBH line, so it is the fastest way to find the part in a catalog. In this case the seal fits a 32 mm shaft, a 44 mm housing bore and a 7.00 mm height. The Lx profile means a single lip with a spring, made for rotating shafts that see continuous lubrication. Before installation, confirm the shaft and bore measurements and make sure the contact surface is clean, with no burrs or scratches.

Seals of this size show up in gearboxes, reducers, centrifugal pumps, electric motors, compressors and transmission equipment, as well as machine tools, food processing equipment and conveyor systems. The job is always the same: hold the lubricant in and keep contaminants out. On equipment that runs with heavy vibration or high temperature, inspect the shaft and housing condition before you replace the seal, since wear in those areas can shorten the life of a new part.

Choosing a radial shaft seal comes down to four values: shaft diameter, housing bore, height and design type. An Lx seal suits rotating shafts with continuous lubrication. If the equipment runs dry or under pressure, a different profile may be needed. During installation, coat the lip with the same oil used in the equipment, press the seal in evenly and avoid striking the lip with tools. The spring should face the lubricant side, and the seal must seat fully in the housing.

To get a quote for seal 5410, send the code or the three dimensions. A photo of the old seal or the assembly drawing also works. We check the manufacturer's data sheet and can suggest alternatives within the DBH line or from other brands we carry. Where space permits, we look at options with different heights or designs to fit your equipment.

For a quote on the DBH 5410 oil seal, message us on WhatsApp with the code or your dimensions. We will come back with the options that suit your application. MR Industrial Accessories supplies bearings, power transmission components, seals and mounting tools.