DBH 5060 radial shaft seal — 30 x 47 x 10

DBH 5060 belongs to radial shaft seal, part of our Seals range. Tell us how many you need by WhatsApp or email and we'll get back to you promptly with a quote for 5060 and any equivalents.

The DBH 5060 is a radial shaft lip seal built to keep lubricant where it belongs and keep dust, water and other contaminants out of rotating equipment. With a 30 mm shaft diameter, a 47 mm housing bore and a 10 mm height, it fits a wide range of gearboxes, pumps, motors and power transmission assemblies. The Lx design pairs a sealing lip with a metal case that presses into the housing bore. We supply it as part of our seals and oil seals line.

The part number breaks down the way most seals do: 5060 identifies the size, and the dimensions are 30.00 mm for the shaft (d), 47.00 mm for the housing bore (D) and 10.00 mm for the height (h). The Lx designation refers to the construction — a sealing lip combined with a metal outer case. That case is what holds the seal in the bore by press fit, while the lip rides against the shaft to form the sealing line. It is a standard replacement item, so the same size and design can be sourced under this designation in the industrial market.

Seals of these dimensions show up in gearboxes, centrifugal pumps, electric motors, compressors and conveyor rollers. In every case the job is the same: hold oil or grease inside the housing and block dust, water and particles that would otherwise reach the bearings. Agricultural equipment and road machinery are common users too, since sealing against dirt is what keeps those components running.

Selection comes down to three measurements: shaft diameter, housing bore and height. Shaft tolerance and surface finish matter as much as the size — a shaft that is too rough will wear the lip early. At installation, lubricate the lip, keep it square to the shaft, and press it in without hammering on the sealing element. If the application runs at high speed or under elevated pressure, it is worth looking at a reinforced design or asking us for guidance.

To get a quote, send the complete part number or the dimensions of the seal you are replacing. We can also search for alternatives within the same series or from equivalent manufacturers, matching the dimensions and design type. The more detail you provide — diameters, height, lip type, material — the more precise the recommendation will be. Reach us on WhatsApp or by email and our team will reply promptly.