DBH 1191 radial shaft seal — 46 x 94.2 x 8/10

DBH 1191 belongs to radial shaft seal, part of our Seals range. Tell us how many you need by WhatsApp or email and we'll get back to you promptly with a quote for 1191 and any equivalents.

The DBH 1191 is a radial shaft seal with an A 293 design, used to keep lubricant in and contaminants out where a shaft turns inside a fixed housing. It fits a 46 mm shaft, a 94.2 mm housing bore, and a height of 8.00/10.00 mm. You will find it in gearboxes, pumps, and other power transmission equipment running with oil or grease. MR Industrial Accessories supplies this brand and helps you confirm the right seal for the job.

This seal carries the 1191 designation and the A 293 lip and metal case geometry. The dimensions to check before ordering are shaft 46 mm, housing 94.2 mm, width 8.00/10.00 mm. The two height figures mean the lip can sit in either of two positions, depending on which way pressure acts or how much room the housing gives you. The A 293 design is made for oil retention on rotating shafts at moderate speeds.

Typical locations include gearboxes, reducers, centrifugal pumps, conveyor rollers, and belt or chain drives, as well as any assembly where dust or water must stay out of the lubricated side. Because it is a wear part, watch for leaks, noise, or falling lubricant levels and replace it when they appear. Removal and installation call for no special tooling.

Before fitting, inspect the shaft for burrs or wear at the contact area and make sure the housing is clean and undistorted. Coat the lip with the same oil or grease the equipment uses, then press it in. The 8.00/10.00 mm height lets you pick the position that matches the housing depth. If the shaft shows a deep groove, look at an offset-lip seal or a wear sleeve instead. Speed, temperature, and lubricant type drive the final selection.

For a seal equivalent to the DBH 1191, send the 1191 code, the full designation, or the three dimensions. A photo of the part and the housing also helps. We compare that information against the product data of the manufacturers we supply and come back with a compatible option.

Quotes go out on WhatsApp or by email. Send the 1191 code or 46 x 94.2 x 8.00/10.00 mm and we will take it from there. If this seal sits in critical equipment, include the operating conditions so we can point you to the best match.