DBH 1007/85 radial shaft seal — 15.87 x 28.55 x 9.52

DBH 1007/85 belongs to radial shaft seal, part of our Seals range. Tell us how many you need by WhatsApp or email and we'll get back to you promptly with a quote for 1007/85 and any equivalents.

The DBH 1007/85 is a radial shaft seal built for rotating shafts. It keeps lubricant where it belongs, inside the housing, and blocks dust, water and other particles from reaching bearings and bushings. The Mz design uses a single lip with a spring, and the size is compact: 15.87 mm at the shaft, 28.55 mm at the housing bore and 9.52 mm in height. MR Industrial Accessories supplies this brand for maintenance teams that need the exact size on hand.

The code breaks down in a practical way. The DBH line covers this style of seal, and 1007/85 identifies the specific size within it. Reading the dimensions in order: shaft 15.87 mm, housing 28.55 mm, height 9.52 mm. The Mz configuration means one lip plus a spring, which suits lubricated rotating shafts. The elastomer lip rides on a ground surface while the outer body holds the fit in the bore. This is a direct replacement, so the three measurements have to line up with the original bore, or leakage will follow.

Where does a seal this size show up? Gearboxes, pumps, electric motors, reducers and other power transmission assemblies are common hosts, along with machine tools, conveyors and hydraulic circuits that need oil or grease contained. The small shaft diameter makes it a frequent choice in compact assemblies running at moderate speeds. In every case the job is the same: protect the bearings and keep the assembly running by holding lubricant in and contamination out.

Installation calls for a few checks. Look over the shaft for burrs or marks before the seal goes in, since anything sharp can cut the lip. Coat the lip with the oil or grease already used in the unit. Press the seal in square to the shaft and avoid striking the lip directly; a tube or spacer that seats on the outer diameter works well. The 9.52 mm height tells you how much room the bore needs. A worn shaft may call for a repair sleeve. Speed, temperature and fluid type all affect selection, so cross-check the data sheet.

Need an equivalent? Send the code 1007/85 or the three measurements and we can search the same series or other brands we carry. We can also advise when the bore tolerance differs or the shaft has been ground. The original part number is not required; shaft, bore and height are enough to start. Message us on WhatsApp and we will come back with the options.

MR Industrial Accessories supplies the DBH brand within its seals and oil seals range. If the machine is still running, do not wait for a leak to take out the bearings. Send the code 1007/85 on WhatsApp and we will prepare a quote. We can also help you pin down the size if you are unsure, and we handle seal replacements for industry.