V-belt Dayco CP65
- Brand
- DAYCO
- Category
- Power transmission
- Subcategory
- V-belts
- Section
- C
- Series
- Classical wrapped industrial belts
We reply promptly.
Tell us the quantity you need and request a quote by WhatsApp or email.
Can't find the exact model? Tell us the part number or model you need. We'll track it down and quote it, whether or not it appears in our catalog.
Description
DAYCO CP65 belongs to v-belt, part of our Power transmission range. Tell us how many you need by WhatsApp or email and we'll get back to you promptly with a quote for CP65 and any equivalents.
The Dayco CP65 is a classical V-belt in the C profile, with a 1752.6 mm length, 22 mm top width, 14 mm height and a 40° angle. It is built for industrial drives where a wrapped classical belt is the specified replacement. To match it to the belt being replaced, confirm the profile and the length first.
Start by reading the marking on the back of the old belt. The profile letter and the length are the two values that decide fit, and the CP65 should only go on a drive that calls for a C profile belt at 1752.6 mm. Where the old belt is worn or the marking is gone, measure the top width and the height across a straight section and compare them with the 22 mm and 14 mm of the CP65.
The 40° angle is the included angle of the belt cross-section, and it should agree with the groove angle of the pulley it runs in. A belt that sits too high or too low in the groove will not transmit correctly, so check the sheave for wear and for correct alignment before fitting a replacement.
If a drive uses more than one belt, replace the full set at the same time so the load stays shared across all strands. Send the part number, the profile and the length when you request a quote, and the team can confirm the CP65 or suggest an equivalent.
Dimensions
- Section
- C
- Length
- 1752.6mm
Frequently asked questions
- How do I confirm the Dayco CP65 is the right belt for my drive?
- Check the marking on the old belt for a C profile and a 1752.6 mm length. If the marking is not readable, measure the top width and height of the old belt and compare them with the 22 mm and 14 mm of the CP65.
- What should I send to request a quote for this belt?
- Send the part number CP65, the profile C and the length 1752.6 mm. If you are replacing a different belt, include its marking or its measured dimensions so the team can confirm the match or suggest an equivalent.
- Should I replace all belts on the drive at once?
- Yes. On a multi-belt drive, fitting one new belt alongside worn belts leaves the new belt carrying more than its share of the load. Replace the set together so all belts work evenly.