V-belt Dayco AP74
- Brand
- DAYCO
- Category
- Power transmission
- Subcategory
- V-belts
- Section
- A
- Series
- Classical wrapped industrial belts
We reply promptly.
Tell us the quantity you need and request a quote by WhatsApp or email.
Can't find the exact model? Tell us the part number or model you need. We'll track it down and quote it, whether or not it appears in our catalog.
Description
DAYCO AP74 belongs to v-belt, part of our Power transmission range. Tell us how many you need by WhatsApp or email and we'll get back to you promptly with a quote for AP74 and any equivalents.
The Dayco AP74 is a classical wrapped V-belt in the A profile, built for standard industrial drives. Before you fit a replacement, inspect the drive so the new belt is not damaged by a worn sheave or a misaligned shaft. We supply this belt to maintenance, engineering and purchasing teams across the US, Canada, Mexico and South America.
The AP74 measures 1930.4 mm in length, with a 13 mm top width, an 8 mm height and a 40 degree angle. Those figures come from the belt itself, so check the marking on the back of the old belt and compare it against the profile and length before ordering.
Inspect the sheave grooves for wear, cracking, corrosion or embedded debris, and confirm the grooves match the A profile. Check that the shafts are parallel and the sheaves are aligned, since misalignment and worn grooves are common causes of short belt life. Look at the bearings and the driven equipment as well, and correct anything you find before the new belt goes on.
On multi-belt drives, replace the full set at the same time so the load stays even across the belts. Note the part number on the back of the old belt and the quantity you need, then send both to us by WhatsApp or email and we will confirm the belt or suggest an equivalent.
Dimensions
- Section
- A
- Length
- 1930.4mm
Frequently asked questions
- What are the dimensions of the Dayco AP74?
- It is an A profile classical V-belt with a length of 1930.4 mm, a top width of 13 mm, a height of 8 mm and a 40 degree angle.
- What should I check before fitting this belt?
- Inspect the sheave grooves for wear or damage, confirm they match the A profile, and check shaft alignment and bearings. Correcting these first helps the new belt run properly.
- What do you need to quote the Dayco AP74?
- Send the part number and the quantity by WhatsApp or email. If you are replacing a full set, include the number of belts on the drive so we can quote the complete set.