BGL OHA2340H hydraulic sleeve
- Brand
- BGL
- Category
- Bushings and sleeves
- Subcategory
- Hydraulic sleeve
We reply promptly.
Tell us the quantity you need and request a quote by WhatsApp or email.
Other brands for this category
Ask us for alternatives. We check every equivalent against the part number and your application.
Can't find the exact model? Tell us the part number or model you need. We'll track it down and quote it, whether or not it appears in our catalog.
Description
BGL OHA2340H belongs to hydraulic sleeve, part of our Bushings and sleeves range. Tell us how many you need by WhatsApp or email and we'll get back to you promptly with a quote for OHA2340H and any equivalents.
The BGL OHA...H hydraulic sleeve sits between a shaft and its bearing, holding the connection while making assembly and removal easier. Oil is fed through internal and external channels under pressure, so the sleeve slides with far less force when the joint has to come apart. It is aimed at medium and large shafts starting at 140 mm, where maintenance calls for repeated dismounting.
Reading the code helps you order the right part. OHA marks the hydraulic sleeve type with an oil channel on the outside, and the trailing H confirms the hydraulic design. The digits in the middle, as in OHA2332H or OHA2348H, point to the size and the diameter the sleeve fits. Every reference in the series works the same way: channels spread the oil so the sleeve can be installed and, more importantly, taken off again.
These sleeves suit equipment built around large-diameter shafts that is opened up often. Cement, mining, steel, paper and material handling operations use them in gearboxes, mills, presses and other heavy machines. MR Industrial Accessories supplies them to plants looking to cut maintenance time and keep shaft surfaces intact during service work.
Selection comes down to the shaft: its diameter, its tolerance and the condition of its surface. Pressurized oil does the heavy lifting, pushed through the channels to form a film that lets the parts slide. When mounting, verify alignment and keep impacts away from the channels. Clean oil and sound seals go a long way toward a long service life and a dismounting job that leaves no damage.
Sleeves from other makers that follow the same dimensional standard can stand in for a BGL unit. Give us another brand's code, or a part you cannot identify, and we will point you to the matching alternative. Since interchangeability depends on dimensions and channel type, check the full designation and the shaft measurements before you swap anything.
To get a quote on the BGL OHA...H hydraulic sleeve you need, send the code or the shaft size to MR Industrial Accessories by WhatsApp or email. We reply promptly with the correct reference and guidance for your application.
Dimensions
Dimensions and tolerances: Message us the part number on WhatsApp and we'll verify its dimensions and version with the manufacturer's datasheet.
Frequently asked questions
- How is a BGL OHA...H hydraulic sleeve installed?
- It goes between the shaft and the bearing. Pressurized oil is injected through the channels so the sleeve slides into place. Clean the surfaces and check alignment before tightening, and follow the manufacturer's instructions for oil pressure and procedure.
- What shaft sizes does it cover?
- It is intended for medium and large shafts, from 140 mm upward. Smaller diameters call for other solutions. Within that range, the OHA...H sleeve simplifies mounting and especially dismounting.
- Can another brand's sleeve replace it?
- Yes, provided the dimensional standard and channel type match. If you only have another brand's code or an unidentified part, send the details to MR Industrial Accessories and we will identify the compatible alternative and quote it.